3 Bar Slide (LV10)

Standard 3 Bar Slide for 2" webbing. Uses the simple 3 Bar Slide wrapping technique. Most commonly used for HANS specific shoulder belts or anti-sub straps.

If you are running in an SFI 16.5 series, you need the LV11NC.

Wrapping directions available Here.

Part Price Purchase
sr LV10.A $3.20

2 Bar Slide (LV17)

This is a 2 Bar Slide designed for use with 3" webbing. Its sole use is to thightly wrap a 3" shoulder belt around a bar or pin. It is lighter than a 3 Bar Slide and offers virtually no slip when wrapped correctly. Even a correctly wrapped 3 Bar Slide will has what is called microslip - when a small amount of webbing slips through the bracket when a significant load is placed on the webbing.

While this 2 Bar Slide is safer, it is much harder to wrap in if you are not used to doing it. Once you figure out the trick, it's not hard at all. Wrapping directions are shown Here.

Part Price Purchase
sr LV17 $18.00

2 Bar Slide (LV4)

This is a 2 Bar Slide designed for use with 2" webbing. It is found on almost all Schroth harnesses because it has virtually no microslip under significant load. It can be used to wrap 2" webbing against a harness bar, or to wrap in an end fitting.

Uses the more complex 2 Bar wrapping technique. Directions are available Here

Part Price Purchase
sr LV4 $3.75
sr LV4 NC $5.00

3 Bar Slide (LV7)

This 3 Bar Slide is designed to be used to wrap any 3" webbing to a harness bar, or to wrap any end fitting into a 3" piece of webbing. This is the bracket found on all 3" shoulder belts.

Uses the simple 3 Bar Wrapping technique. If you are in an SFI 16.5 series, be sure to select the LV7NC option.

Wrapping directions available Here.

Part Price Purchase
sr LV7 $4.00